The installation process is the opposite of the removal process.
Installing a sliding door handle.
Insert the wheels on the top of the first door into the top track.
Rotate the handle 90 clockwise lift the handle up then rotate it back and remove the handle from the door.
For the inside handle keep in mind that the door is wider than the opening.
The installation of the sliding door handle is very straightforward.
The center of the handle should be about 36 inches from the bottom of the door.
Place the outside handle near the edge of the door as you would any handle or door knob.
The runner is what the wheels roll along so the door can slide back and forth.
Prime line sliding glass door handle set 6 5 8 in diecast and wood hook style flush mount keyed.
Hold the door so the top is tilted backward.
Use this video to check that your door is properly prepared.
If your kit doesn t include a handle you can buy one and either screw or bolt it to the door.
Finish re installing the handle by inserting the two screws through the handle and into the backing plate.
Continue reading below our video of the day.
On a standard pre drilled door you ll be done installing your passage lock in just minutes using only a tape measure and a phillips screwdriver.
Place the strap on the face of the door with the wheel side facing towards the back.
Then latch the wheels on top of the door onto the back runner of the top track.
Make sure that the holes for hardware will line up with the door so that it can be installed simply and easily.
The wheels have a groove in the middle for the rail to rest in.
Install the new handle.