I Think My Garage Door Track Is Too Far Out

If you have noticed your garage door shaking or making a lot of noise as it moves along the track rust could be the cause.

I think my garage door track is too far out.

In the configuration only a vertical track is needed and the door moves up and bumps out from the wall only enough to accommodate the opener. Tracks that are not securely fastened to the garage wall can create problems by moving too much coming off the wall entirely or just being slightly loose enough to misdirect the rollers. Misaligned tracks are another common cause for a garage door going off track. Ideally the track will be positioned so that 1 2 to 3 4 of the shaft is visible.

If it s way off balance it could actually fall of the tracks and injure someone. If the door is 8 ft. Hammer the bent track back into the correct shape against the wood until it has returned to proper alignment with the rest of the track. Tall an additional 8 9 of vertical headroom would be needed.

When rust develops on a garage door opener s hardware the door s wheels have difficulty gliding over the affected area. 3 retighten the track fasteners. If you re trying to slow down the speed at which your garage door opens simply raise the tracks up. Too close and the door will bind.

With the door in the down position take a look at the margin on the track and rollers. How to adjust garage door tension. If you or the person who installed your garage door didn t install it securely you may end up having problems with your garage door tracks later down the line. There is no horizontal track.

Open and close the door manually a few times to test if the rollers are operating smoothly. A track that is too far away will cause the roller to pull out of the hinge. If the track is too far away from the door the door could fall. A garage door that s out of alignment can be very dangerous.

With misaligned tracks the risk of the rollers coming off the tracks gets much higher. The door may get jammed and there could be an emergency situation where you need to get your car out. This will give the roller room to move in or out as needed. You want the track to be parallel with the door 1 2 to 3 4 away from the door.

This usually happens when the bolts holding the horizontal tracks get loose causing the bracket to wobble at the slightest unnatural vibrations of the door. When you re finished adjusting the tracks the distance between them and the garage door should be 5 inches 1 3 cm otherwise the door may stick. Move the end of the track the minimum increment and try the door. Tracks aren t secured properly.

If the tension is too loose the springs that help lift the.