How To Tightened Loose Kwik Set Door Handles

The detent is a spring activated pin concealed or small thin plate attached to the spindle that protrudes into a doorknob notch which prevents rotation.

How to tightened loose kwik set door handles.

Give yourself a little room to spin properly and tighten the set screw. Look at the shaft to see if it s threaded or not. From there tighten the set screw back into place. That s because modern door hardware uses a hidden mechanism called a detent to fasten the doorknob that can only be released using a small screwdriver tip or the end of a paper clip depending on your style of hardware.

Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Look around the collar on the doorknob and identify the set screw that is threaded into the collar. If you are experiencing the lever falling off the set screw is still in the shaft. Remove the screw and slip the lever handle off the rod.

That silver button is the set screw. It s fairly easy to tighten up a loose doorknob that has exposed set screws. If threaded twist on the handle on the shaft until its neatly up against the door. Identify the screw in the doorknob collar.

If you remove the lever and on one side of the shaft there is a hole and the other side there is a silver button. Older buildings usually have this type of doorknob as well as newer door hardware. Dealing with loose door handles and loose door knob problems in general can be a hassle but it s one of the many responsibilities property owners have to shoulder. Some tips on how to tighten loose door handles and find the hidden screws for models by kwikset schlage yale defiant ezset and mortice lock sets.

Take doorknob to hardware store if necessary. I show how i tightened my loose door handle that is made by kwikset. Since door knobs and door handles are so widely used many property owners have had to deal with a loose door knob or a loose door handle at some point. Step 2 inspect the rod s surface and locate the groove where the set screw needs to be secured.

Straighten a paper clip and insert it into the hole. Once triggered the lever or lock trim can be removed from the door. If unthreaded pop the knob onto the shaft and snug to the door. Determine whether you will need an allen wrench or a screwdriver based on the style of set screw which you will find on the bottom of the door lever.