How To Sync Genie Garage Door Opener With Remote

While the indicator light is blinking press the button on your remote.

How to sync genie garage door opener with remote.

Syncing your garage door opener to your car s homelink system. If the genie door opener does not operate one or more of the dip switches is not set correctly. The power head is attached to. Press the remote control button programmed in step 2 until the garage door opener lights flash or just hold 4 seconds.

This calibrates the opener and syncs it with your remote control. Push down the same button on your garage door remote. Try to locate the learn button. Press and release the learn button on the garage door opener or door control.

Place the ladder under the garage door power head and climb so you are within reach of the control buttons. This sets the in car remote transmitter to be your garage door openers make transmitter but you are not done. Hold your transmitter up near the selected button pressing both the garage door remote and the selected in car transmitter button simultaneously. How to reprogram a genie garage door remote.

Slide each individual switch on the remote control to the exact position each switch is on the door opener with your finger. It usually only takes a few seconds and when the sync is successful the opener will indicate success via a flashing light or audio queue. Test the new garage door remote by pressing once to see if the door moves. Syncing a garage door opener.

For easy troubleshooting when things go wrong it is better to buy your remote from the manufacturer of your garage door. Place the battery cover back on the remote control and press the white button on the remote control. To program a new remote into the system hold the learn button until the indicator light blinks on the opener. As quickly as possible after the learn button has been pressed hold down the remote button which is usually on the vehicle s ceiling near the dashboard lights.

Make sure that there are no obstructions people or animals in the path of the garage door since it will move during programming. Press and hold the learn button on the side of the power head for approximately 10 seconds or. Hold down on the buttons until the in car led light flashes rapidly.