Either move the clock to a different location where reception is possible or set the time manually.
How to set a wall clock.
To manually set the time during normal run time press the m set button for 5 seconds to enter manual setting mode.
The status led on the front turns orange.
Setting a wall clock or bedside clock 1.
Sometimes you may have to remove a battery cover.
2 wait 24 hours then compare the time on the regulator clock to the time displayed by an accurate time.
Dials are usually located at the back of the clock.
Press and hold the blue pairing button on the back of device for up to 10 seconds.
It s best to do this late in the evening because longwave radio signals are normally not received during the day.
Rotate the minute hand only in a clockwise direction to set the clock hands to the time.
In some locations if the time signal is not able to be received by the clock there are 2 alternatives.
Setting an atomic wall clock is simple.
If you have to reset your clock it s likely that you need a new battery before doing so.
Insert the correct number of fresh aa lr6 alkaline batteries in the battery compartment according to the polarity markings.