How To Reprogram Garage Door Remote Genie

Repeat this process for each additional remote control you have.

How to reprogram garage door remote genie.

Place the ladder under the garage door power head and climb so you are within reach of the control buttons. This will lock in a new code and you will be able to use your remote controls normally. Use the 2 curved rectangular buttons on the top half of the remote to reset and reprogram the opener. Press and hold down the square button on the motor head until the round blue led light come on then release the square button.

The long purple led button will start to blink. Push down the same button on your garage door remote. Looking up in your garage at the bottom of your genie motor cover is a set of black buttons depicted in the drawing below along with two led lights shown here in grey. Press and release the learn code button on the receiver while the red led is blinking press your transmitter button 3 times.

How to program your genie garage door opener remote control. To reprogram your new and or existing remote controls. Step 2 press and hold the learn button on the side of the power head for approximately 10 seconds or until the indicator light turns off.