How To Remove Broken Key From Door Lock

Carefully spray the oil into the lock in between the key and the cilinder.

How to remove broken key from door lock.

Silicone lubricant will help the key slide out easily and since it is water resistant it will. From there apply the technique again and you will get the key out bit by bit. Next use a pair of pliers to pull out the broken key. If the key broke in the middle and the part you re.

Other than pulling you may also try prying out the broken key. Turn the key so that the keyway slot is in the exact position it was in when you inserted the key. If it appears the powder isn t penetrating use spray lubricant. Wd 40 is the best option because you can use the long thin spout to spray as close to the key as possible.

It the key is not too far inside of the lock tweezers or small needle nose pliers will pull the key out. This is the correct position for the pin tumblers to align in the cylinder. You re in a hurry and turn the key too hard when locking the door. Select a silicone spray.

This will probably only move the key out a bit. It can help to lubricate without gumming up the lock. This is particularly helpful if the lock has been difficult to operate recently. It s a frustrating experience.

How to remove a broken key from a door lock. It it s further in you can use a small jigsaw blade or paperclip to rake it out or a glue gun stick to seal to the key and pull the key out. You can remove a broken key from a lock using tools you already have in your home. Suddenly you re standing there with half the key in your hand and the other half stuck in the lock.

Then pull the broken key towards you. With your other hand. Older keys have weakened spots that cause breakage. Once removed you can insert a paper clip or other small rods into the back of the lock to push out the broken key.

The best bet is to hold the nozzle of the plastic tube against the lock opening and squeeze very sharply in the hope that the pressure will force the powder into the lock and around the broken key. Because it s a liquid it can seep into areas that a powder can t go. With open access to the cylinder remove the c clip or nut on the back of the lock. Don t be afraid to be generous with the oil.

Just place them in enough to be able to apply pressure firmly. Look at how much of the key has broken free of the lock. Then reassemble the cylinder and the lock.