Isolate the piece of siding you need to remove and find its outermost edge on either side.
How to remove aluminum sliding doors.
Determine the size of the screwdriver you ll need reach back into the gap with your screwdriver and adjust that screw counter clockwise as far as it will go.
Pry out the remaining.
Do the same on both the left and right ends of the sliding door.
Then tilt it slightly with help and remove it from the upper track of the door frame as well.
Put a screwdriver into this hole and turn the screw counterclockwise to bring the roller as far up into the bottom of the sliding panel as possible.
Open the door and locate the head stop screw at the top corner of the door frame right where the door would touch the frame when it closes.
Once you remove all the screws lift the door up and make sure that it is completely removed from the bottom track of the door frame.
Keep lowering the panel until it is completely out of the upper track and free.
This screw may be tightly fixed.
How to remove reinstall aluminum siding.
Remove this cap because as you ll notice it is covering a gap inside of which is a screw.
4 removing the sliding door before removing the door slide it to the point in the track where you see an indent.
If you can t undo it with a manual screwdriver try a power screwdriver.
In order to remove the sliding one effectively lift it upwards into the upper track and ask a helper to push the bottom gently and carefully toward you.
Unscrew the head stop with a power or phillips screwdriver.
If not you will need to find the roller adjustment hole in the bottom corners of the sliding panel.
Gently wiggle the tool side to side until you separate the interlocking pieces.
Sliding patio doors have two separate units namely the sliding door panel and the stationary panel.
This should allow the slider to come out.
2 insert the end of a pry bar by tapping it with a hammer to get behind any door or window stops.