Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
How to put a sliding screen door back on track.
Luckily returning it to its proper place is not difficult.
On feb 5 2018.
First locate the adjustment screws along the bottom of the outside face of the door frame shown or on the door s inside edge.
Lower the door when both wheels are on the track.
The fix is a cinch.
It should run well a push back and forth a bit but if out of line it will need adjusting.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
Lift up on the door while you push the bottom of the door into the lower track.
Release the wheel when it s over the track.
Spray track slot and runners with wd 40.
Lift each of the wheels with a flat head screwdriver while you push the door in.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
These must be properly placed back on their tracks to return the door to its functional self.
Place the top of the sliding door in the track.
Check to ensure that the bottom of the door frame is not dragging on the track.
Raise the wheel by turning the adjustment screw counterclockwise.
That balky screened patio door that catches and sticks.
Wd 40 is good but if you don t have it just use some cooking spray to test the effectiveness of it.
Turn each screw counterclockwise to raise the wheels and lower the door so that you can lift the door up and out of the track.
Step 5 slide the 2 phillips screwdriver into the adjust hole located above the loosen screw.
Get a sliding screen back on track.
Reinstall the sliding panel by inserting the top of the panel into the top track and lifting the door onto the track.
Two sets of rollers are affixed to both the top and the bottom and these roll or ride along the track.