How To Program Your Garage Door Remote

This video is for liftmaster chamberla.

How to program your garage door remote.

Program the remote after locating the learn button you should press and hold on to it until the indicator light blinks on the opener. Within 30 seconds. For units with no removable light cover the button will be on the same side as the wire antenna. If you have a wall control use this button if not use the learn.

Then go back to the car and press and hold the button you taght the remote to. Follow the cars instructions to program the remote control. While the indicator light is blinking press the button on your remote. If the lightbulb on the opener flashes once it has been programmed.

Press and release the learn button press and release twice if your liftmaster opener is equipped with a myq. Press the button while the indicator light is blinking. Locate the learn button on your opener. Remove the plastic light lens cover if applicable.

After that you need to test the remote by pressing it once to see if the door will move. The short remote control wire antenna and the learn or set button are typically under this cover. Press and hold the program button on the remote control until the led on the front of the remote control turns on. Press and release the remote control button you wish to use the number of times corresponding to the garage door opener type with a learn button described below.

Once the remote control has been taught to the car you go to the garage door opener and press and release the learn button. Access the garage door opener motor housing. Simply follow these easy steps.