2 turn the lock lightly in the direction you would use to open it.
How to pick a door latch lock.
Insert the card between the door and the frame.
A spring bolt lock is a spring loaded lock with an angled edge.
Slide the card.
Insert your lever into the bottom half of the lock.
In some cases door latch plate mortises might need to be cut or enlarged.
The tension wrench is the key no pun.
Turn the wrench in the direction that the lock turns.
The throw of a vertical deadbolt engages by interlocking with a set of cast metal rings affixed to the frame of the door.
Pick the lock using your tools.
This one has picked every.
I prefer the bogota rake that has three ridges.
Begin by removing the screws from the door knob on the interior side of your door.
Lock picking technique 1.
Tilt the card toward the doorknob to help it slide in along the latch then bend the card back the other way to push the latch back.
Stick the bent end into the bottom of the lock keeping it as low as possible while still getting the lever as deep into the barrel as possible.
Insert pick into the upper part of keyhole and.
The bottom of the keyhole is called the shear line.
This can be a bit hard to do if you re not sure which way it.
Choose a card you can replace.
Insert it into the gap in the door below the latch.
Slide the card into the space between the door and the door frame where the lock is.
The pin tumbler lock.
This method will almost surely bend your card and could risk breaking it.
Start by unfolding end of the paper clip.
Simple latches such as swing latches are also easy to open with a paper clip.
This part is.
Make sure you have a spring bolt lock.
Using a credit card 1.
Maintain this tension throughout the process.
Then just slide the paper clip up until the latch is lifted free from the hook called the keeper.
Insert pick at top of lock.
You may need to wiggle the card back and forth a few times to get the latch open.
The rings surrounding the bolt make this lock essentially pry proof.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
The cylinder of the lock is nothing more than a little container that houses the rest of the components.
First insert the tension wrench into the bottom part of the lock and rotate it in the direction you would turn the key to unlock it to place tension on the lock.
This allows you to pull the door knobs off the door from both sides.
In the instance of a door containing glass panes a double cylinder deadbolt might be employed.
Then slowly wiggle the pick into the top part of the lock using a gentle up and down motion.
Insert tension wrench into the bottom of key hole and apply slight pressure.